SFACT slicer

Draft

SFACT is a slicer program for 3D printing. It is a fork of the wellknown skeinforge program that is somewhat easier to use since it relies on some calibration procedure. As a result, there are no flow rate settings, only flow rate modifiers (ratios).

See also:

• Skeinforge for RapMan
• Slicers and user interfaces for 3D printers

Links

• SFACT thread in the skeinforge settings (reprap.org)

Software

• http://www.reprapfordummies.net/downloads/SFACT.tar.gz
• GiHub directory (downloads)

Manuals (don't know which is ok, the version installed doesn't fit any)

• Sfact (reprap wiki, probably the best information)
• SFACT the new Skeinforge (July 19, 2011)
• PublicPad version of the FAQ

---

Content of this article has been taken from EduTechWiki (en) or EduTechWiki (fr) at the date indicated in the history. DKS was the main founder and main contributor of EduTechWiki. If you cite this page you also must cite and credit EduTechWiki, according to the CC BY-NC-SA license. View the pageinfo-toolboxlink for this article.