SFACT slicer: Difference between revisions
Jump to navigation
Jump to search
m (→Links) |
m (Text replacement - "$" to " {{edutechwiki}}") |
||
(One intermediate revision by the same user not shown) | |||
Line 21: | Line 21: | ||
[[Category: 3D printing]] | [[Category: 3D printing]] | ||
{{edutechwiki}} |
Latest revision as of 01:19, 10 April 2021
SFACT is a slicer program for 3D printing. It is a fork of the wellknown skeinforge program that is somewhat easier to use since it relies on some calibration procedure. As a result, there are no flow rate settings, only flow rate modifiers (ratios).
See also:
Links
- SFACT thread in the skeinforge settings (reprap.org)
- Software
- Manuals (don't know which is ok, the version installed doesn't fit any)
- Sfact (reprap wiki, probably the best information)
- SFACT the new Skeinforge (July 19, 2011)
- PublicPad version of the FAQ
Content of this article has been taken from EduTechWiki (en) or EduTechWiki (fr) at the date indicated in the history. DKS was the main founder and main contributor of EduTechWiki. If you cite this page you also must cite and credit EduTechWiki, according to the CC BY-NC-SA license. View the pageinfo-toolboxlink for this article.